The installation of LCD splicing screen should not only choose the installation site carefully,
but also pay attention to the light around the installation environment, but also need to pay
attention to the wiring, and there are also requirements for the frame. Now let's talk about how to
install the LCD splicing screen.
When installing the LCD splicing screen, pay attention to distinguishing its power line and signal line
when wiring, and install them in different places to avoid interference.
Although the brightness of the LCD splicing screen is very high, it is still limited after all, so the light
around the environment where you choose to install cannot be too strong. If it is too strong, you may
not see the picture on the screen. The light that may enter near the screen (such as a window) should
be blocked if necessary, and the light should be turned off when the device is running to ensure the normal
operation of the device. Do not install a light directly in front of the screen, just install a downlight.
In order to facilitate the maintenance of the LCD splicing screen in the future, the frame edging must be a
detachable edging. A gap of about 25mm is reserved on each side of the inner edge of the outer frame from
the outer edge of the splicing wall. For large-scale splicing walls, the margin should be appropriately increased
according to the number of columns.
The installation skills and steps of the LCD splicing screen system are explained here. For more splicing screen
information, please pay attention to Shenzhen Mercedes Technology.